Pioneer AVIC-N2 Service Manual page 255

5
8. VTR check
8. VTR check
[joy stick down] It progresses to the next inspection.
• External input image (VTR input image) is displayed and voice is outputted.
• You can move on to the next inspection by the [ ] key on the remote controller.
9. FM multiplex tuner error rate measurement
9. FM multiplex tuner error rate measurement
FM Frequency
Frequency to check
Blocks Received Correctly
Blocks with one bit corrected
Blocks with two bits corrected
Blocks Received with error
[<- -> to adjust FM frequency]
[joy stick down] It progresses to the next inspection.
• FM multiplexing error is measured.
• In the case of UC model, this inspection is not performed and the system will move on to the next inspection.
• Default frequency is 87.5MHz.
• When entering this mode for the first time, the result of measurement at the time of test disc boot up will be
displayed.
• After the measurement is taken, the frequency can be changed by the [ ] and [ ] keys.
• 500 blocks will be measured, and if there are 450 or more blocks without error, then it will be determined as OK.
• Only in the case of OK, you can move on to the next inspection by the [ ] key on the remote controller.
5
6
Push Back key to go to re-check.
AVIC-N2/XU/UC
6
7
87.50
87.50
0500
0000
0000
0000
7
8
A
B
C
D
E
F
255
8