1
2. Dual Illumination color check
A
B
• Color switching for dual illumination can be made.
• In the case of UC model, this inspection will not be performed, and the system will move on to the next
inspection.
• Color is changed to GREEN/LED by the [NAVI] key on the remote controller.
• Move on to the next inspection by the [ ] key on the remote controller.
3. Touch Panel check
C
D
• Touch panel inspection must be performed at 16 locations.
• If the coordinate obtained by pressing the white spot is within the effective range, it will be determined as
OK, and the next white spot will be displayed.
• If the coordinate obtained is outside of the effective range, it will be determined as NG.
• If all 16 locations turned out to be OK, then this test is considered to be OK.
• If coordinate cannot be obtained in approximately 5 seconds after the white spot is displayed, the inspection is
determined as NG.
• Only if the inspection is OK, the inspection will move on to the next step by the [ ] key on the remote controller.
E
F
252
1
2
2. Dual Illumination color check
[NAVI] The color of illuminations is changed.
[joy stick down] It progresses to the next inspection.
AVIC-N2/XU/UC
2
3
3
4
4