Pioneer AVIC-N2 Service Manual page 245

5
[ X-3016 DVD Test ]
[X-3016 DVD Test] EDC-1
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Layer : 0
ID : 20 03 0A 63
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
[1] cursor right
[2] cursor left
[3] cursor up
[4] cursor down
[5] Star EDC-1
[6] Disc Eject
Press [OK] to make a selection
Press [BACK] to DVD Test top(EDC end)
EDC-1 : Performs consecutive EDC tests.
EDC-2 : Performs EDC tests for each block.
ID : Performs ID of the test.
[1] Moves the cursor to the right by one increment.
[2] Moves the cursor to the left by one increment.
[3] Moves the cursor up by one increment.
[4] Moves the cursor down by one increment.
[5] Starts the EDC test.
[6] Ejects the Disc.
[OK] Executes.
[BACK] Returns to the test mode menu.
[ X-3016 DVD 1-Layer Servo. Test(1-0) ]
[X-3016 DVD 1-Layer Servo.Test(1-0)]
Status : Power On
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
[1] Focus Close
[2] Focus Search(Start/Stop)
[3] CRG + (Start/Stop)
[5] (LD-ON->LD-OFF / LD-OFF->LD-ON)
[6] CRG HOME
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
FE Offset : 0000 0000
AS Offset : 0000 0000 ENV Offset : 0000 0000
TG Offset : 0000 0000
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Press [OK] to make a selection
Press [BACK] to DVD-1
Test items are basically the same for both DVDs and CDs.
Status : "Power On (during normal conditions)."
[1] Closes in on the focus (proceed to servo test 2-0).
[2] Performs a focus search operation (S-curve measurement). Focus operation will then be stopped.
[3] Moves the carriage (external). The carriage transition operation will then be stopped.
[4] Moves the carriage (internal). The carriage transition operation will then be stopped.
[5] Performs LD-ON/OFF operation.
[6] Returns the carriage to the home position.
[BACK] Returns to the DVD test menu screen display.
* This operation will not be performed until the coefficient figures have been received.
* Focus closing and searching will not operate unless the LD-ON setting is made to less than 9 seconds.
5
6
Data : 1000 0000
[4] CRG - (Start/Stop)
TE Offset : 0000 0000
DBAL : 0000 0000
AVIC-N2/XU/UC
6
7
7
8
A
B
C
D
E
F
245
8