Dust Connection; Mains Connection; Starting Operation - Jet JTS-600X Operating Instructions Manual

Loosen 2 screws and lift the sliding
table end cover.
Slide the sliding table carefully over
the 4 guide rollers (Fig 8).
Fig 8
Lower the sliding table end cover and
tighten screws.
Sliding Table Adjustment:
The sliding table is adjusted ex works.
The sliding table must be aligned to
run parallel to the sawblade and table
surface to be 0,1 - 0,4 mm higher than
the machine table. Use rip fence
profile to check (Fig 9).
Fig 9
Adjustment:
The sliding table guide assembly can
be adjusted up down and in parallel to
the sawblade.
Grub screws allow a guided micro
adjustment in vertical and horizontal
direction (Fig 10).
Fig 10
The sliding table guide rollers are
adjustable by eccentric shafts.
Mounting Sawblade
See chapter 7.1
Adjusting Raving Knife
See chapter 7.2
Mounting Saw Guard
See chapter 7.3
Mounting crosscut table
See chapter 7.8
Fig 11
Mounting crosscut fence
See chapter 7.9

5.3 Dust connection

Before initial operation, the machine
must be connected to a dust extractor.
The suction should switch on
automatically when the saw is
switched on.
A hose, a Y-piece and a hose support
are supplied with the machine.
Mounting Hose Support:
Attach the hose support to the table
extension with the supplied fastening
clip (Fig 12).
7
Fig 12
The flow rate on the suction port dia.
100mm must be 20m/sec.
Flexible hoses must be of non-
flammable quality, and must be
connected to the machine ground
system.

5.4 Mains connection

Mains connection and any extension
cords used must comply with
applicable regulations.
The mains voltage must comply with
the information on the machine
licence plate.
The mains connection must have a
16A surge-proof fuse.
Only use connection cables marked
H07RN-F
Connections and repairs to the
electrical equipment may only be
carried out by qualified electricians.
Attention:
-Check first if the saw spindle runs
freely and if all safety devices are
fitted before starting the machine.
For safety reasons this must only be
done without the sawblade installed!
- If the direction of rotation is not
correct, the phase converter inside the
CCE Euro plug must be pushed in and
turned 180°.
(Clockwise direction of the spindle is
correct).

5.5 Starting operation

You can start the machine with the
green On-button. The red Off-button
stops the machine.