Canon SmartBase MPC600F Service Manual page 101

SmartBase MPC600F/MPC400 Chapter 4: Maintenance & Service
No.
##783
##784
##785
##787
##788
##789
##790
##791
##792
##793
##794
##795
##799
d) New error codes and recovery methods
Those error codes that have been added starting with the product and those error codes for which
remedies unique to the product are offered are shown together with causes and remedies, where
applicable.
##342 Cleaning absorption waste ink capacity full
Solution:
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
Tx or Rx Definition
[ TX ] Exceed protocol retransmission limit or T5 time (60 seconds) after
EOR-EOM transmission during ECM Tx
[ TX ] Receive ERR after EOR-EOM transmission during ECM Tx
[ TX ] Exceed protocol retransmission limit due to failure to receive
significant signals after EOR-EOP transmission during ECM Tx.
[ TX ] Receive DCN after EOR-EOP transmission during ECM Tx
[ TX ] Exceed protocol retransmission limit or T5 time (60 seconds) after
EOR-EOP transmission during ECM Tx
[ TX ] Receive ERR after EOR-EOP transmission during ECM Tx
[ RX ] Transmit ERR after EOR-Q reception during ECM Rx
[ TX/RX ] Receive non-significant signals during ECM mode procedures
[ RX ] Fail to detect PPS-NULL between partial pages during ECM Rx
[ RX ] Time over due to failure to receive valid frame during high speed
signal Rx upon ECM Rx
[ TX ] Receive all 0 PPR during ECM Tx
[ TX/RX ] Trouble in the decoding processing during communication
[ TX ] System error
Unlike errors that trigger the "CHECK PRINTER" message, This error is
programmed so that it cannot be cleared using the Resume button. Replace the
waste ink absorber as follows in the error occurs:
(1) Select 5. INK ABS CAPA under #7 PRINTER in service mode, and the
counter to 0.
(2) Check to make sure that no image exist in memory; then, turn off the power,
remove the appropriate parts, and replace the waste ink absorber.
4-22