Unpack The Xcm8903 Chassis; Install The M6100 Switch Chassis - NETGEAR M6100 Hardware Installation Manual

Unpack the XCM8903 Chassis

CAUTION:
The XCM8903 chassis weighs almost 65 pounds. Proper lifting and
moving of the chassis requires two people.

To unpack the XCM8903 chassis:
Place the container on a clean flat surface, and cut all straps securing the container.
1.
Unpack the hardware from the boxes.
2.
Carefully remove the hardware, and place it on a secure and clean surface. Remove all
packing material.
Make sure that all items are present. See
3.
If any item is missing or damaged, contact your local NETGEAR
Note:
reseller for replacement.
Inspect the products and accessories for damage. Report any damage immediately.
CAUTION:
Do not use the fan tray handle to lift or maneuver the XCM8903 chassis.
This handle is not designed to support the weight of the chassis.

Install the M6100 Switch Chassis

You must provide the following tools and equipment:
Four rack-mount screws appropriate for your rack system.
•
Screwdriver that fits the rack-mounting screws you will use.
•
NETGEAR M6100 Switch Chassis
Package Contents
Install an M6100 Series Chassis
32
on page 7.