Table of Contents
Advertisement
4. Connecting a video source to the KODAK DP1050 ULTRA
The procedure for connecting a video
source to the KODAK DP1050 ULTRA
is the same for S-video and Composite
video
SECAM, PAL N and PAL M modes are manually
selected by pressing "Green Button". If the right format
is not found first time, press again. The video format is
stored separately for each connector.
1.
Make sure that the video source and the
KODAK DP1050 ULTRA are switched off.
2.
Connect the video cable from the Video out connector
of the video source to the correct video connector on
the KODAK DP1050 ULTRA plug panel.
3.
Connect the audio cable from the Audio out
connectors of the video source to the Audio in
connectors on the KODAK DP1050 ULTRA.
Connect the red plug to the red connector, and the
other plug to the white connector. Red is the right
stereo channel.
10
4.
When all the connections are done and verified,
switch on the video source and the KODAK
DP1050 ULTRA.
5.
The KODAK DP1050 ULTRA will now automatically
display the pictures from the video source. If not,
see the section 'What do I do if'.
Figure 9:
Connecting to video sources
Contents
Advertisement
Table of Contents
