Qos > Bandwidth Control - D-Link DES-1210-08P Reference Manual

4 Configuration
TxPort FramesTotal – Displays the total number of LLDP frames transmitted on the port.
RxPort FramesDiscarded – Displays the total discarded frame number of LLDP frames received on
the port.
RxPort FramesErrors – Displays the Error frame number of LLDP frames received on the port.
RxPort Frames – Displays the total number of LLDP frames received on the port.
RxPortTLVsDiscarded – Each LLDP frame can contain multiple pieces of information, known as
TLVs. If a TLV is malformed, it is counted and discarded.
RxPortTLVsUnrecognized – Displays the number of well-formed TLVs, but with an known type
value.
RxPort Ageouts – Each LLDP frame contains information about how long time the LLDP information
is valid. If no new LLDP frame is received within the age out time, the LLDP information is removed,
and the Age-Out counter is incremented.
Click Refresh to renew the page, and click Clear to clean out all statistics.
QoS > Bandwidth Control
The Bandwidth Control page allows network managers to define the bandwidth settings for a specified port's
transmitting and receiving data rates.
From Port / To Port: A consecutive group of ports may be configured starting with the selected port.
Type: This drop-down menu allows you to select between RX (receive), TX (transmit), and Both. This
setting will determine whether the bandwidth ceiling is applied to receiving, transmitting, or both
receiving and transmitting packets.
No Limit: This drop-down menu allows you to specify that the selected port will have no bandwidth limit.
Enabled disables the limit.
Rate (64-1024000): This field allows you to enter the data rate, in Kbits per second, will be the limit for the
selected port.
Click Apply to set the bandwidth control for the selected ports.
Figure 4.72 – QoS > Bandwidth Control
NOTE: For DES-1210-52, the TX rate for Gigabit
ports can only be configured in multiples of
1850kbps. If any other value is used, the system
automatically rounds it down to the lower multiple
of 1850.
For DES-1210-28, the TX rate for Gigabit
ports can only be configured in multiples of
63kbps. If any other value is used, the system
automatically rounds it down to the lower multiple
of 63.
5 3
5 3
DES-1210 Series Switch Web UI Reference Guide