System > Port Description - D-Link DES-1210-08P Reference Manual

4 Configuration
Speed: Gigabit Fiber connections can operate in 1000M Full Force Mode, Auto Mode or Disabled. Copper
connections can operate in Forced Mode settings (1000M Full, 100M Full, 100M Half, 10M Full, 10M Half),
Auto, or Disabled. 100M Fiber connections support 100M Full Force Mode, 100M Half Force Mode, or
Disabled. The default setting for all ports is Auto.
MDI/MDIX:
A medium dependent interface (MDI) port is an Ethernet port connection typically used on the Network
Interface Card (NIC) or Integrated NIC port on a PC. Switches and hubs usually use Medium dependent
interface crossover (MDIX) interface. When connecting the Switch to end stations, user have to use
straight through Ethernet cables to make sure the Tx/Rx pairs match up properly. When connecting the
Switch to other networking devices, a crossover cable must be used.
This switch provides configurable MDI/MDIX function for users. The switches can set as an MDI port in order
to connect to other hubs or switches without an Ethernet crossover cable.
Auto MDI/MDIX is designed on the switch to detect if the connection is backwards and automatically
chooses MDI or MDIX to properly match the connection. The default setting is "Auto" MDI/MDIX.
Flow Control: You can enable this function to mitigate the traffic congestion. Ports configured for full-duplex
use 802.3x flow control, half-duplex ports use backpressure flow control. The default setting is Disabled.
Link Status: Reporting Down indicates the port is disconnected.
System > Port Description
Port description can be given on this page.
From Port / To Port: Specify the range of ports to describe.
Description: Specify the description of ports.
Click Apply to set the description in the table.
NOTE: Be sure to adjust port speed settings
appropriately after changing connected cable
media types.
Figure 4.25 – System > Port Description
26
DES-1210 Series Switch Web UI Reference Guide