L2 Functions > Lldp > Lldp Port Settings - D-Link DES-1210-08P Reference Manual

4 Configuration
LLDP: Specify the LLDP state to be enabled or disabled. By default, the LLDP state is Disabled.
Message TX Hold Multiplier (2-10): Set the Time-to-Live for the LLDP advertisements transmitted. If the
Time-to-Live of LLDP advertisements expire, the advertised data will be deleted from the neighboring
Switch's MIB. The default value is 4 hops.
Message TX Interval (5-32768): Set the time interval to transmit the LLDP advertisement. The default value
is 30 seconds.
LLDP Reinit Delay(1-10): Enter a time delay for the LLDP port. This LLDP port will wait for a specific
interval before it re-initializes. The default is 2 seconds.
LLDP TX Delay(1-8192): Configure the minimum time delay interval for any LLDP port which transmits
successive LLDP advertisements due to changes in the LLDP MIB content. The default value is 2 seconds.
Click Apply to implement changes made.
L2 Functions > LLDP > LLDP Port Settings
The Basic LLDP Port Settings page displays LLDP port information and contains parameters for configuring
LLDP port settings.
From Port/ To Port: A consecutive group of ports may be configured starting with the selected port.
Notification State: Specifies whether notification is sent when an LLDP topology change occurs on the port.
The possible field values are:
Enabled – Enables LLDP notification on the port.
Disabled – Disables LLDP notification on the port. This is the default value.
Admin Status: Specifies the LLDP transmission mode on the port. The possible field values are:
TX_Only – Enables transmitting LLDP packets only.
RX_Only – Enables receiving LLDP packets only.
TX_and_RX – Enables transmitting and receiving LLDP packets. This is the default.
Disabled – Disables LLDP on the port.
Figure 4.61 – L2 Functions > LLDP > LLDP Global Settings
Figure 4.62 – L2 Functions > LLDP > LLDP Port Settings
DES-1210 Series Switch Web UI Reference Guide
48