Drying And Cycle Tips - Maytag Bravos MED6300TQ Technical Education

NOTE: During a Timed Cycle, you can change
the settings for Time, Temp, the WRINKLE PRE-
VENT setting and the End of Cycle Signal.
™
5. (OPTIONAL STEP) If desired, select OP-
TIONS. For more details, see "Options,"
page 3-6.
6. (OPTIONAL STEP) If desired, press END OF
CYCLE SIGNAL. A signal will sound to alert
you when a cycle ends. For more details,
see "End of Cycle Signal," page 3-7.
7. Press START. Be sure the door is closed.
• If you do not press Start within 5 min-
utes of selecting the cycle, the dryer
automatically shuts off.
• If you wish to end your drying cycle after
pressing Start, press PAUSE/CANCEL
twice.
STOPPING, PAUSING OR
RESTARTING
To stop or pause your dryer at any time
Open the door or press PAUSE/CANCEL
once. Press PAUSE/CANCEL twice to cancel
a cycle.
To restart the dryer
Close the door. Press START until dryer
starts.
NOTE: Drying will continue from where the
cycle was interrupted if you close the door
and press Start within 5 minutes. If the cycle is
interrupted for more than 5 minutes, the dryer
will shut off. Select new cycle settings before
restarting the dryer.

DRYING AND CYCLE TIPS

Select the correct cycle and dryness level or
temperature for your load. If a Sensor Dry Cycle
is running, the display shows the estimated
cycle time when your dryer is automatically
sensing the dryness level of your load. If a Timed
Cycle is running, the display shows the exact
number of minutes remaining in the cycle.
Cool Down tumbles the load without heat
during the last few minutes of all cycles. Cool
Down makes the loads easier to handle and
reduces wrinkling. The length of the Cool Down
depends on the load size and dryness level.
DRYING TIPS
• Follow care label directions when they are
available.
• If desired, add a fabric softener sheet. Fol-
low package instructions.
• To reduce wrinkling, remove the load from
the dryer as soon as tumbling stops. This is
especially important for permanent press,
knits and synthetic fabrics.
• Avoid drying heavy work clothes together
with lighter fabrics. This could cause over-
drying of lighter fabrics and lead to increased
shrinkage or wrinkling.
CYCLE TIPS
• Dry most loads using the preset cycle set-
tings.
• Refer to the Sensor Dry or Timed Preset
Cycle Settings charts, page 3-5 (in the
"Cycles" section) for a guide to drying vari-
ous loads.
• Drying temperature and dryness level
are preset when you choose a Sensor
Dry Cycle. You can select a different
dryness level, depending on your load,
by pressing Dryness and choosing
More, Normal, Less or Damp.
NOTE: You cannot use the Timed Cycle
Adjust and you cannot choose a Tem-
perature with the Sensor Dry Cycles.
• If you wish to adjust the cycle length of
a Timed Cycle, press the Timed Cycle
Adjust up or down arrows. Adjust the
temperature of a Timed Cycle by press-
ing Temp until the desired temperature
is selected.
NOTE: You cannot choose a dryness
level with Timed Cycles.
3-3