Copying Crash Log Data Content To A Destination Device - HP procurve series 4100gl Management And Configuration Manual

File Transfers
Copying Diagnostic Data to a Remote Host, PC, or Unix Workstation
At this point, press
[Enter]
and start the
Xmodem command
sequence in your
terminal emulator.
Figure A-10. Example of sending a Crash Log for Slot C to a File on an Attached PC
A-18

Copying Crash Log Data Content to a Destination Device

This command uses TFTP or Xmodem to copy the Crash Log content to a PC
or UNIX workstation on the network. You can copy individual slot information
or the master switch information. If you do not specify either, the command
defaults to the master data.
copy crash-log [<slot-id | master>] tftp <ip-address>
Syntax:
<filepath and filename>
copy crash-log [<slot-id | master>] xmodem
slot-id = a - h, and retrieves the crash log or crash data from
where:
master
For example, to copy the Crash Log for slot C to a file in a PC connected to
the switch:
the processor on the module in the specified slot.
Retrieves crash log or crash data from the switch's
chassis processor.