HP procurve series 4100gl Management And Configuration Manual page 389

Figure 14-32. Example of Stack Listing with Two Stacks in the Subnet
Syntax:
stack member <switch-number>
mac-address <mac-addr>
[password<password-str>]
In the destination Commander, use show stack all to find the MAC address of
the Member you want to pull into the destination stack. For example, suppose
you created a new Commander with a stack name of "Cold_Waters" and you
wanted to move a switch named "Bering Sea" into the new stack:
You would then execute the following command to pull the desired switch
into the new stack:
HP4108(config)# stack member 1 mac-address 0060b0-df1a00
Where is an unused switch number (
1
Since a password is not set on the Candidate, a password is not needed in this
example.
You could then use
show stack all
Using a Member CLI To "Push" the Member into Another Stack. You
can use the Member's CLI to "push" a Series 4100GL switches stack Member
into a destination stack if you know the MAC address of the destination
Commander.
Syntax: stack join <mac-addr>
where: <mac-addr> is the MAC address of the Commander for the desti-
nation stack.
Converting a Commander to a Member of Another Stack. Removing
the Commander from a stack eliminates the stack and returns its Members to
the Candidate pool with
Move this switch into the "Cold Waters" stack.
).
SN
again to verify that the move took place.
disabled.
Auto Join
HP Procurve Stack Management
Configuring Stack Management
14-39