Follett MCC400A Installation, Operation And Service Manual page 14

Step 2 – Installing ice machine on slide-out track
A. When ice machine is shipped with slide-out track accessory (follow either A or B)
1. Connect inlet water, drain, and power supply to back of vertical utility panel.
2. Place ice machine on slide-out track assembly.
3. Connect drain and water lines.
4. Connect electrical cords from ice machine to appropriate plug and connect to power supply.
B. When ice machine is installed in and shipped with counter
1. Remove two outer rear screws from ice machine and install supplied spacer and screw (Fig. 3).
2. Place ice machine on slide-out track assembly.
3. Connect drain and water lines.
4. Connect electrical cords from ice machine to appropriate plug and connect to power supply.
5. Remove pin from adjustable leg.
6. Place hold-down strap over leg block and secure strap to slide-out assembly with supplied screws (Fig. 4).
7. Reinstall pin in leg block.
8. At job site remove hold-down strap and make utility connections at rear utility panel.
counter front
grille supplied with air-cooled
RIDE model ice machines
air in
(air-cooled units only)
Fig. 3
Fig. 4
position track accessory so that 51mm (2") duct supplied with air-
cooled RIDE model ice machine mates with back of counter opening
hold-down strap
(for installation; remove
and discard)
14
utility connections made at back side of
panel (see next page)
Remove screw. Install supplied
screws and spacers.
supplied screws
(for installation; remove and discard)