Follett MCC400A Installation, Operation And Service Manual page 12

Field wiring diagrams
Field wiring diagram is intended only to aid electrician or technician in understanding how equipment works.
Should local codes require a hard-wired connection and/or shielded wiring, eliminate the cord and plug(s) and
follow the appropriate fi eld wiring diagram.
MCC400A/W and C/ER400A/W ice machines have separate power supply from dispenser.
Electric disconnects required within 3m (10 ft) for all hard-wired connections.
Recommended junction box preparation of hard-wired RIDE model ice machines.
1. Replace upper (power) strain relief with a cord connector.
2. Mount two 51mm x 102mm (2" x 4") junction boxes using supplied holes in ice
machine face.
3. Make power and bin signal connections.
25, 50 or 110 ice and water dispenser with ONE RIDE model ice machine
Electric
power
source
Dispenser
junction box
X
VU155/VU300 ice and beverage dispenser with either ONE or TWO autofi ll ice machine kits
DISPENSER
Electric
Left junction box
power
source
Lower ice machine
junction box
(bin signal)
Right junction box
Electric
power
source
Upper ice machine
junction box
(power)
X
Ice machine #1
(optional)
Lower junction box
(24V bin signal)
Ice machine #2
(optional)
Lower junction box
(24V bin signal)
12
LEGEND
WIRENUT FIELD
CONNECTIONS
X EQUIPMENT
GROUND
BLACK
WHITE
GREEN
BLUE
YELLOW
RED
Electric
Upper junction box
power
(power)
source
GND X
Electric
Upper junction box
power (power)
source
X