Maytag Neptune MAH9700 User Manual page 18

Reactor
Slide 30 –
Slide 31
Remove screw
Remove screw and slide
reactor out of bracket
Slide 32
The reactor coil is wired in series with line internally
"dead" board complaint. A resistance check across
Select normal wash and let the washer fill.
Measure the water level at the 6 o'clock position
the rear of the spinner. The water level should be
approximately 3 ½"
in the control board. An open coil would result in a
the coil leads should indicate less than 1 OHM
Twist bracket
counterclockwise
14