Loading Printer Paper; Manually Installing Paper And Ribbon; Manually Installing Paper - Datamax S2000i User Manual

3 Loading Printer Paper

3.1 Manually Installing Paper and Ribbon


Open the hinged paper supply door to load paper or replace the printer ink cartridge.

To unlock the top hinged paper cover, hold the printer with both hands and place each thumb on the two
locking ribs located below the grooved sections on the top cover.

Push the locking ribs in-and-up to open the paper door.

3.2 Manually Installing Paper


Open the paper supply door by pushing up the locking ribs (figure 4).

Turn on the printer by pressing the ON switch.

Remove any paper remaining in the printer mechanism, using the FEED switch or pulling the paper in
forward direction.

Unroll a leader from the new roll (about 3 inches); do not place roll in the printer at this time.

Place the straight edge of the leader just under the roller in the print head and feed about 3 inches of the
new roll of paper into the print head using the FEED switch.

Place paper roll in the printer.

Feed the leading edge of the paper into the slot of the hinged cover.

Lower the hinged cover and lock.

Pull the 3 inches of paper forward against the teeth of the paper tear bar and pull to either side to tear off
the paper.

The printer is then loaded with paper and ready to use.
FIGURE 4: Loading printer paper
5