Burner Removal; Fcm Replacement - Napoleon XIR4N Installation And Operating Instructions Manual

8.4

BURNER REMOVAL

A. Remove the glass door, see "DOOR REMOVAL AND INSTALLATION" section.
Remove the logs, see "FINISHING" section.
B. Remove the 9 screws that secure the log support in place. Lift
.
the support out
C. Remove the 2 screws holding the rear burner tube and lift it
up and out.
8.5

FCM REPLACEMENT

TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THE APPLIANCE.
THE APPLIANCE MAY BE HOT. DO NOT SERVICE APPLIANCE UNTIL IT HAS COOLED.
A. To access the fan control module, you must fi rst pull out
the appliance, allowing enough room to access the left
access plate.
B. Remove the screws holding the access plate in position.
C. Unplug the fan control module from the junction box. Unplug
the night light plug and blower plug (if applicable) from the
fan control module.
D. Remove the 2 screws securing the fan control to the access
plate and replace. NOTE: Ensure ON/OFF switch is in the
"ON" (-) position.
E. Reinstall the plugs and access plate
WARNING
!
ON/OFF SWITCH
D. Remove the 4 screws that secure the pan burner in place and
lift the burner up and out.
ACCESS PLATE
27
W415-1035 / A / 10.21.11