Clarion DXZSBSUS8 Owner's Manual page 16

Basic Operations
• Adjusting the treble
The treble gain and treble FREQ (center
frequency) can be adjusted as follows.
The adjustment can only be performed when the
DZE is set to "OZE OFF".
2-1. Select "TREBLE".
2-2. Press the
[~II
ENT] button.
2-3. Push the [SEEK PANEL] leftward or
rightward and select from:
"T GAIN"
,->
"T FREO"
3-1. Press the [UP] or [ON] button to adjust the
gain and FREQ (center frequency).
T GAIN: -6 to +6 (The factory default
setting is "0")
T FREO: 8KHz/12KHz (The factory default
setting is "12K")
3-2. Press the
[~II
ENT ] button to return to the
previous mode.
• Adjusting the sound restorer
The sound restorer enriches the playback of all
types of music files that have undergone any
level of data compression.
2-1. Select "S RESTOR".
3-1. Press the [UP] or [ON] button to adjust.
Each time you press the [UP] or [ON]
button, the sound restorer changes in the
following order:
"OFF"
+-·10
"1"
...-10>
"2"
«(--..
"3"
*
The factory default setting is "OFF".
Set this adjustment in accordance with the
music source used.
OFF: For music sources compressed at
high bit rate
1: For music sources compressed for high
quality at low bit rate
2: For music sources compressed for
standard quality at low bit rate
3: For music sources compressed for low
quality at low bit rate
• Setting high pass filter
2-1. Select "HPF".
3-1. Press the [UP] or [ON] button to select the
setting. Each time you press the [UP] or
[ON] button, the setting changes in the
following order:
"THROUGH"
<-+
"50Hz"
<-+
"80Hz"
<-+
"120Hz"
*
The factory default setting is "THROUGH"
(through).
t
6
DXZ585USB
• Setting low pass filter
2-1 .. Select "S-W LPF".
3-1. Press the [UP] or [ON] button to select the
setting.
Each time you press the [UP] or [ON]
button, the setting changes in the following
order:
"THROUGH"
<->
"50Hz"
<+
"80Hz~·H
"120Hz"
*
The factory default setting is "THROUGH"
(through).
• Adjusting the balance
2-1. Select "BALANCE".
3-1. Press the [UP] button to emphasize the
sound from the right speaker, press the
[ON] button to emphasize the sound from
the left speaker.
*
The factory default setting is "CENTER".
(Adjustment range: L12 to R12)
• Adjusting the fader
2-1. Select "FADER".
3-1. Press the [UP] button to emphasize the
sound from the front speaker, press the
[ON] button to emphasize the sound from
the rear speaker.
*
The factory default setting is "CENTER".
(Adjustment range: R12 to F12)