Troubleshooting - Electrolux EIDW6105GS0 Technical & Service Manual

T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g
P P r r o o b b l l e e m m
Dishwasher will not
1. Fuse (blown or tripped).
operate when
2. 120 VAC supply wiring
turned on. No lights
on top of console.
3. Electronic control board
4. Door switch (open contacts).
5. User may have locked out
Dishwasher will not
1. Customer not programming
operate when
turned on. No lights
2. Door switch not opening.
on top of console.
3. Wires loose on control.
4. Defective electronic control.
5. Key pad not programming
Dishwasher will not
1. Water not turned on.
fill with water.
2. Dishwasher not programmed
3. Fill hose from valve to left
4. Stopped up water valve.
5. Water valve not opening.
Wash motor stops
1. Motor loosing power.
in cycle.
2. Debris in wash pump stalling
3. Motor shutting down on
4. Control not receiving proper
5. Control not interpreting input
C C a a u u s s e e
connection faulty.
faulty.
display.
unit properly.
control.
properly.
side air duct kinked or
pinched.
motor.
overload.
input from tachometer.
from tachometer.
C C o o r r r r e e c c t t i i o o n n
1. Replace fuse or reset breaker.
2. Repair or replace wire fasteners at
dishwasher junction box. Check power
to unit from house power supply.
3. Check power at the control from the j-box.
Kill power to unit and re power looking for
lights or failure code. Replace defective
control board.
4. Lights on console go out when door is
closed, if the door switch does not open
the lights may not come on. Replace
defective door switch.
5. Press and hold left arrow on EWDW6505G
for 5 seconds to relight console lights.
1. Instruct customer in operation of
dishwasher.
2. If the door switch is not opening and
closing properly the control may not know
the door is closed to start unit.
3. Check all wire to the electronic control.
4. If control is wired properly and not starting
unit the electronic control may need to be
replaced.
5. Replace defective key pad.
1. Check water supply to dishwasher.
2. Instruct customer in operation of
dishwasher.
3. Check hose to be sure it is not kinked or
pinched off. Replace if needed.
4. Check screen in water valve for debris,
clean the valve or replace if needed.
5a. Check float and float switch for proper
operation. Replace if needed.
5b. Check wire at electronic control and at
water valve to make sure both are
connected properly.
5c. Check for power from control to valve
Replace water valve if needed.
1. Check wire connection at control and motor
2. Clean wash pump and filters.
3. Check voltage. Rotate motor fan or impeller.
Replace motor.
4. Check electrical connections.
Replace motor.
5. Check electrical connections.
Replace control.
6-2