Roller Assembly And Guide Rail Removal; Corner Trim And Cabinet Clip Bracket Removal; Top Frame Brace Removal - Electrolux EIDW6105GS0 Technical & Service Manual

R R o o l l l l e e r r A A s s s s e e m m b b l l y y & & G G u u i i d d e e R R a a i i l l R R e e m m o o v v a a l l
The four roller assemblies are mounted to the
interior sidewall of the tub. The screws securing
the roller assemblies pass through washers,
retaining plates and the leg and hinge assembly,
before passing through the unit frame and
fastening into the roller assemblies.
(See Figure 5-26)
1. Remove unit from its installation position.
2. Remove upper and lower rack assemblies.
3. Using a #20 Torx bit, extract the 2 screws from
each retainer plate on the exterior of unit. Use
caution when removing the second set of
screws as the roller assemblies and guide rail
will fall free inside the unit as the screws are
removed.
C C o o r r n n e e r r T T r r i i m m a a n n d d C C a a b b i i n n e e t t C C l l i i p p B B r r a a c c k k e e t t R R e e m m o o v v a a l l
The corner trim and cabinet clip bracket must be
removed prior to removing the top frame brace
and the leg and hinge assembly. (See Figure 5-27)
To remove the corner trim and cabinet clip bracket:
1. Remove unit from its installation position.
2. Using a #20 Torx bit, extract screw securing
the corner trim to the cabinet clip bracket.
3. The corner trim has a bend along its bottom
edge that fits over the unit frame. Rotate
corner trim until top portion is free of the
cabinet clip bracket, then pull upwards until
bent edge clears the unit frame.
3. Using a #20 Torx bit, extract screw from under
the cabinet clip bracket. Lift from outside
edge until retaining clip is free of unit frame.
T T o o p p F F r r a a m m e e B B r r a a c c e e R R e e m m o o v v a a l l
The top frame brace slides over the leg and hinge
assembly and is secured with screws. The door
strike must be removed prior to removing the top
frame brace.
To remove the top frame brace:
1. Remove unit from its installation position.
2. Remove the door strike from top frame brace.
3. Remove the corner trim and cabinet clip
bracket.
4. Using a #20 Torx bit, extract the four screws
from each end of the top frame brace securing
the top frame brace to the leg and hinge
assembly. (See Figure 5-27)
C C o o m m p p o o n n e e n n t t T T e e a a r r d d o o w w n n
Roller
Assembly
F F i i g g u u r r e e 5 5 - - 2 2 6 6 . . R R o o l l l l e e r r A A s s s s e e m m b b l l y y & & G G u u i i d d e e R R a a i i l l
Corner Trim
Screw
Screw
F F i i g g u u r r e e 5 5 - - 2 2 7 7 . . C C o o r r n n e e r r T T r r i i m m a a n n d d C C a a b b i i n n e e t t C C l l i i p p
4-13
Washers
Screws
Retaining
Plate
R R e e m m o o v v a a l l
Cabinet Clip
Bracket
Top Frame Brace Screws
R R e e m m o o v v a a l l