Water Line - Electrolux EIDW6105GS0 Technical & Service Manual

I I n n s s t t a a l l l l a a t t i i o o n n I I n n f f o o r r m m a a t t i i o o n n
L L e e v v e e l l i i n n g g a a n n d d A A n n c c h h o o r r i i n n g g D D i i s s h h w w a a s s h h e e r r W W i i t t h h i i n n
C C a a b b i i n n e e t t s s
(Continued)
6. If levelers need to be removed, make sure that
the floor is free of all obstructions.
7. Carefully place dishwasher inside cabinet area
such that is centered in opening. Use caution
when moving dishwasher to prevent damage
to cabinet, dishwasher and floor.
8. Front of door needs to be even with the front
of adjoining cabinets. Front levelers should
allow 5/16" below underside of countertop to
top of console.
9. Check that dishwasher is level from side to
side by placing a level against the top front
section of the tub. (See Figure 2-9)
10. Check that the dishwasher is level from front
to back by taking out the lower rack, place
level on the lower rack wheel support at the
bottom of the tub.
11. Adjust levelers up or down until dishwasher is
level. Holes need to be pre-drilled using a #5
drill to secure unit.
12. Screw mounting brackets firmly to cabinet
using screws provided in literature packet.
(See Figure 2-10)
13. Open and close dishwasher door slowly.
Ensure that there is clearance to the console.
Adjust accordingly until door opens and closes
freely.
F F i i n n i i s s h h i i n n g g t t h h e e W W a a t t e e r r a a n n d d E E l l e e c c t t r r i i c c a a l l C C o o n n n n e e c c t t i i o o n n
W W a a t t e e r r L L i i n n e e
1. Flush water line before connecting it to water
inlet valve to prevent early clogging of filter
screen. Place a bunched towel over end of line
to prevent splashing. Open water supply valve
for a few seconds and let water drain into a
pan. Turn off water supply at shut-off valve.
2. Route water line to water inlet valve as shown
in Figure 2-2.
3. While firmly pulling water supply line into 90°
elbow, tightly connect water supply to water
inlet valve. Supply line must be free of kinks,
scales, chips, and lubricants.
4. Turn on water supply and check for leaks.
F F i i g g u u r r e e 2 2 - - 9 9 . . C C h h e e c c k k i i n n g g L L e e v v e e l l
F F i i g g u u r r e e 2 2 - - 1 1 0 0 . . T T o o p p M M o o u u n n t t C C a a b b i i n n e e t t C C l l i i p p s s
CAUTION
P P r r o o p p e e r r t t y y D D a a m m a a g g e e
D D o o n n o o t t s s o o l l d d e e r r w w i i t t h h i i n n 6 6 " " o o f f t t h h e e w w a a t t e e r r i i n n l l e e t t v v a a l l v v e e . .
D D a a m m a a g g e e t t o o t t h h e e p p l l a a s s t t i i c c p p a a r r t t s s i i n n t t h h e e v v a a l l v v e e m m a a y y
o o c c c c u u r r . . U U s s e e c c a a r r e e t t h h a a t t n n o o s s e e a a l l e e r r , , d d i i r r t t , , o o r r o o t t h h e e r r
o o b b j j e e c c t t s s e e n n t t e e r r t t h h e e v v a a l l v v e e . . D D a a m m a a g g e e t t o o t t h h e e f f i i l l t t e e r r
s s c c r r e e e e n n m m a a y y o o c c c c u u r r . . B B e e s s u u r r e e t t h h e e d d i i s s h h w w a a s s h h e e r r i i s s
p p l l a a c c e e d d w w h h e e r r e e t t h h e e w w a a t t e e r r i i n n l l e e t t v v a a l l v v e e w w i i l l l l b b e e k k e e p p t t
f f r r o o m m f f r r e e e e z z i i n n g g . . I I f f t t h h e e v v a a l l v v e e f f r r e e e e z z e e s s , , i i t t m m a a y y r r u u p p t t u u r r e e
a a n n d d f f l l o o o o d d i i n n g g m m a a y y o o c c c c u u r r . .
2-8