Table of Contents
Advertisement
Sequence Setup (Spot Monitor)
The described below let you program the sequence pattern
for the Spot Monitor.
Sequence Timing Setting
This item lets you select between internal and external con-
trol for advancing the sequence on the Spot Monitor.
1. Select either INT or EXT to advance the sequence by
clicking the button.
The item lets you select between internal and external
control for advancing the sequence on the Spot
Monitor.
INT: Advances a sequence by the Dwell Time that was
programmed on the (SPOT) LIVE SEQ SETUP.
EXT: Advances a sequence by the input from pin 5 of
the ALARM port on then rear of the Disk Recorder.
The factory default setting is INT.
2. Select either ON or OFF to enable or disable the auto
skip function by clicking the button.
The item lets you enable or disable the auto skip func-
tion on the Spot Monitor to skip any steps when no
video signal is present.
ON: Enables the auto skip function on the Spot Monitor.
OFF: Disables the auto skip function on the Spot
Monitor.
The factory default setting is ON.
3. Click the [SET] button to execute the selections.
Multi Live Sequence Setting
(Multiscreen Monitor)
There are three sequence patterns to run on the
Multiscreen Monitor.
The items shown below let you program the sequence to
run on the Multiscreen Monitor.
Multi Live Sequence is a series of 16 steps assigned to the
Multiscreen Monitor.
The sequence steps can be combined with four screen
segments (quad) display.
1. Click the MULTI LIVE SEQ SETUP in the underneath of
the SEQUENCE SETUP window.
The window shown in the figure will appear on the dis-
play.
27
2. Select a camera to be displayed in the CAM column for
step 1 by pressing the keyboard.
1 - 16: Displays the image of the selected camera num-
ber.
4A - 4D: Displays the assigned images in quad.
Refer to the QUAD PATTERN SETUP for settings.
––: Disables display and will skip automatically.
3. Select a preset position to be displayed in the PRESET
column for step 1 by pressing the keyboard, if applica-
ble.
01 - 64: Selects a preset position of the assigned cam-
era.
––: No preset position
The factory default setting is ––.
Note: To assign the parameters 1 - 64, the specified
combination cameras are equipped in the system
with a PS.Data* mode.
4. Select a dwell time in the SEC column for step 1 by
pressing the keyboard.
0S: The step will not be displayed on the monitor.
1S - 30S: Selects a dwell time between 1 second and
30 seconds.
5. Repeat the above steps 2 to 4 to program the other
steps.
6. When satisfied with all of the above steps, click the
[SET] button to execute the selections.
Advertisement
Table of Contents
