Sequence Setup; Sequence Setup (Multiscreen Monitor) - Panasonic WJ-HDB502 User Manual

Sequence Setup

These items let you program the sequence pattern for the
Spot and Multiscreen Monitor.
1. Click the SEQUENCE SETUP display in the MULTI-
PLEXER SETUP window.
The SEQUENCE SETUP window as shown in the figure
will appear on the display screen.
2. Select an item or item parameter in the SEQUENCE
SETUP window.
3. To return to the previous MULTIPLEXER SETUP win-
dow, click the MULTIPLEXER SETUP display in the
underneath of the window.
Or open the further divided setup window, click one of
the display in the underneath of the window.
Sequence Setup (Multiscreen
Monitor)
The described below let you program the sequence pattern
for the Multiscreen Monitor.
1. Select either ON or OFF to enable or disable the quad
shift operation by clicking the button.
The item lets you enable or disable the quad shift oper-
ation when the [MULTISCREEN SELECT] button on
the Disk Recorder is pressed.
Quad shift displays an image series such as 4A, 4B, 4C
and 4D previously programmed on four screen seg-
ments.
ON: Enables the quad shift operation.
OFF: Disables the quad shift operation.
The initial factory setting is OFF.
26
2. Select either INT or EXT to advance the sequence by
clicking the button.
The item lets you select between internal and external
control for advancing the sequence on the Multiscreen
Monitor.
INT: Advances a sequence by the Dwell Time that was
programmed in the MULTI LIVE SEQ SETUP win-
dow.
EXT: Advances a sequence by the input from pin 5 of
the ALARM port on the rear of the Disk Recorder.
The factory default setting is INT.
3. Select either QUAD or MULTI GROUP display mode to
be run on the monitor by clicking the button.
The cameras are assigned to 4 groups for recording
with a programmed internal timer.
The item lets you select the sequence pattern to be dis-
played of each group on the Multiscreen Monitor.
MULTI GROUP: Camera images are displayed in
sequence with the minimum quantities of the seg-
ment screen.
QUAD: Camera images are displayed with a 4-segment
screen in sequence.
The factory default setting is QUAD.
4. Select a dwell time for the group sequence by pressing
the keyboard.
1 - 30: Selects the dwell time between 1 second and 30
seconds.
The factory default setting is 2 SEC.
5. Select either ON or OFF to enable or disable the auto
skip function by clicking the button.
The item lets you enable or disable the auto skip func-
tion on the Multiscreen Monitor to skip any steps when
no video signal is present.
ON: Enables the auto skip function on the Multiscreen
Monitor.
OFF: Disables the auto skip function on the Multiscreen
Monitor.
The factory default setting is ON.