Fujitsu ETERNUS DX200F Configuration Manual page 98

Chapter 8 SAN Connection Settings
8.2 Server Connection Setup
12
Confirm that the ETERNUS DX iSCSI name is displayed in [Discovered targets] and that the [Status] is
[Inactive].
13
Select the iSCSI name that is to be the connection target, and click the [Connect] button.
In this example, "CM#0 CA#0 Port#0" with an iSCSI name that is specified in
ter Settings" (page 86)
[Connect To Target] appears.
14
Confirm the controller number at the end of the target name and click the [Advanced] button.
15
On the [Advanced Settings] screen, specify the following items under [Connect using] and click the
[OK] button.
Local adapter: Microsoft iSCSI Initiator
Initiator IP: IP address of the server (A in
is the target.
FUJITSU Storage ETERNUS DX200F All Flash Array Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
Figure 8.1)
98
"8.1.2.2 iSCSI Port Parame-
P3AM-8462-01ENZ0