Fujitsu ETERNUS DX200F Configuration Manual page 3

Fujitsu would like to thank you for purchasing our FUJITSU Storage ETERNUS DX200F All Flash Array (herein-
after referred to as ETERNUS DX).
The ETERNUS DX is designed to be connected to Fujitsu servers (Fujitsu M10, PRIMEQUEST, or PRIMERGY) or
non-Fujitsu servers.
This manual describes all the procedures that are required to start operation of the ETERNUS DX.
This manual is intended for use of the ETERNUS DX in regions other than Japan.
Please carefully review the information outlined in this manual.
About This Manual
Organization
This manual is composed of the following eleven chapters:
• "Chapter 1 Component Names" (page 14)
This chapter provides components names of the ETERNUS DX.
"Chapter 2 Rack Installation" (page 16)
•
This chapter describes the procedure for installing the ETERNUS DX in a rack.
"Chapter 3 Checking the Configuration Environment" (page 21)
•
This chapter describes the environment required for system configuration.
"Chapter 4 Connecting Cables" (page 31)
•
This chapter explains how to connect various cables to the ETERNUS DX.
"Chapter 5 General Settings" (page 34)
•
This chapter describes the basic settings for the ETERNUS DX.
"Chapter 6 Monitoring Settings" (page 59)
•
This chapter describes the settings required to monitor the ETERNUS DX.
"Chapter 7 Power Control Setup" (page 79)
•
This chapter describes the settings required for power control of the ETERNUS DX.
• "Chapter 8 SAN Connection Settings" (page 83)
This chapter describes the settings required to use the ETERNUS DX with a SAN connection.
"Chapter 9 Advanced Copy Settings" (page 115)
•
This chapter describes the settings required to operate Advanced Copy.
"Chapter 10 System Status Check" (page 126)
•
This chapter describes the status check for the ETERNUS DX after system configuration.
"Chapter 11 Solution Configuration" (page 133)
•
This chapter describes storage solutions using the ETERNUS DX.
FUJITSU Storage ETERNUS DX200F All Flash Array Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
3
Preface
First Edition
May 2014
P3AM-8462-01ENZ0