Various Notification Settings; Snmp Trap Setup - Fujitsu ETERNUS DX200F Configuration Manual

Chapter 6 Monitoring Settings
6.2

Various Notification Settings

6
Click the [Set] button to apply the specified settings.
A confirmation screen appears.
7
Click the [OK] button.
The event notification settings are applied.
8
Check the setting completion message and click the [Done] button.
The screen display returns to the [Event/Dump] screen.
6.2 Various Notification Settings
To monitor an ETERNUS DX, perform the required settings for device error notification.
6.2.1

SNMP Trap Setup

SNMP Trap can be sent to the SNMP Manager (monitoring server) when an event occurs in the ETERNUS DX.
The SNMP Trap setting is explained below.
Carefully read this manual and the manuals for the monitoring software (SNMP Manager) that is to be
used before monitoring the ETERNUS DX.
■
ETERNUS DX Settings
The SNMP Trap test setting is explained below.
1
Set up the network environment for the ETERNUS DX.
When the ETERNUS DX and the monitoring server are in different subnet environments, set the Gate-
way IP address and the Allowable IP address (IP address of the monitoring server or the network ad-
dress to which the monitoring server belongs) on the [Setup Network Environment] screen of ETERNUS
Web GUI.
FUJITSU Storage ETERNUS DX200F All Flash Array Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
60
P3AM-8462-01ENZ0