Powering On - Fujitsu ETERNUS DX200F Configuration Manual

Chapter 5 General Settings
5.2

Powering On

AC power is supplied to the ETERNUS DX and the POWER LED on the power supply unit blinks green.
POWER
LED
5.2.2 Powering On
Turn on the PC terminal and the ETERNUS DX.
Follow the procedure below to turn on the ETERNUS DX.
After turning the power on, it takes approximately two minutes for the ETERNUS DX to be in READY state
•
(READY LED (
tics, it may take a longer time (up to ten minutes) for the ETERNUS DX to be in a READY state.
After power-off, wait for about one minute before turning power on again.
•
1
Press the Power switch of the ETERNUS DX.
Power switch
The POWER LED ( ) on the ETERNUS DX is turned on.
2
After approximately two minutes, check that the READY LED ( ) of the ETERNUS DX is lit up.
Power supply unit (PSU#0)
) turns on). If an error is detected in a component during the initial power-on diagnos-
FUJITSU Storage ETERNUS DX200F All Flash Array Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
Power supply unit (PSU#1)
38
P3AM-8462-01ENZ0