GE JKP76 Use And Care Manual page 46

OPERATING THE SELF-CLEANING OVEN
How to Set Oven for Cleaning
Quick Reminder:
1. Press the AUTO SELF CLEAN pad.
2. Press the number pads until the desired Clean
Time appears.
3. Press the START pad.
If the oven is too hot and you start to set a clean cycle,
the word "OFF" will appear in the display. Allow
additional time for cooling before you try to
set the cycle.
1. Follow directions in the Before a Clean
Cycle section.
2. After closing the door, press the
AUTO SELF
AUTO SELF CLEAN pad.
CLEAN
3. Press the number pads until the desired Clean Time
is displayed in the lower left display.
To Stop a Clean Cycle
1. Press the CLEAR/OFF pad.
CLEAR
OFF
46
(continued)
Clean Time is normally 3 hours. You can change
the Clean Time to any time between 2 and 4 hours,
depending on how dirty your oven is.
4. Press the START pad.
START
The lower right display shows the calculated Stop
Time. "LOCKED" flashes in the display while the
door locks automatically, then it appears steadily. It
will not be possible to open the oven door until the
temperature drops below the lock temperature and the
LOCK light goes off.
5. When the LOCK light is off, open the door.
NOTE: Both the lower oven fan and the microwave
fan may operate during the self-clean function and
continue to operate until the oven temperature has
cooled. This is normal, and the fans may continue
to run even after the oven is turned off.
2. When the LOCK light goes off and the oven
has cooled below the locking temperature, open
the door.