Remote Arming By Telephone; Domestic Dialing; Acknowledging Domestic Calls - Bosch ICP-SOL2-P User Manual

Control Panel
If the system is partitioned, the codepad display a number identifying which area the codepad
belongs.
5.15

Remote Arming by Telephone

Arm your system from any remote location using the telephone. For security reasons, the
system cannot be disarmed using this method. Your installer must program this feature to
operate.
How to Remotely Arm Your System by Telephone
1.
2.
3.
Notice!
If your installer programmed answering machine bypass, call the control panel twice to make
a connection with the system. For example, call the telephone number your control panel is
connected to and let the call ring no more than four times. Hang up the telephone. Wait a
minimum of 8 sec before you calling the control panel again.
5.16

Domestic Dialing

Use domestic dialing can be used to call your mobile phone or a relative/friend if your control
panel activates an alarm. Up to four different telephone numbers can be programmed for the
control panel to call when an alarm occurs. Only your installer can program the system to
report in the domestic format. The Master Code holder can change the telephone numbers at
any time.
5.16.1

Acknowledging Domestic Calls

When an alarm condition occurs, the system calls the first programmed telephone number.
When you answer an incoming call, the system repeatedly emits a siren tone followed by a
pause, continuously for 10 times (for example, siren tone, pause, siren tone, and pause).
If you do not acknowledge the call from the control panel during a pause between siren tones,
the control panel hangs up after 10 times and recall the same call number for 2 times. If the
system still can't receive the acknowledge, the system calls the next telephone number.
Pressing the [*] key for 1 sec to 3 sec during the pause acknowledges the call. No further calls
are made for that event. If the call was successfully acknowledged, a tone of decreasing pitch
sounds.
Bosch Security Systems, Inc.
Call the telephone number connected to your control panel.
When the control panel answers the incoming call, a short jingle sounds. To arm the
system, press the [*] key on the touch-tone telephone for 1 sec to 3 sec. If you hear
modem tones when the control panel answers the incoming call, the system was
programmed for remote programming functions by your installer. Wait for a pause
between the tones before pressing the [*] key. After releasing the [*] key on the touch-
tone telephone, two beeps sound, indicating that the system is armed in AWAY Mode.
Hang up the telephone and the system remains armed.
Operation with ICON LCD Codepad | en
User's Guide
25
2014.05 | 01 | F01U298028