Bosch ICP-SOL2-P User Manual page 28

28 en | Glossary of Terms
Term
isolate
master code
monitoring station
panic
sealed
sensor watch
silent alarm
STAY Mode 1
STAY Mode 2
telco arming
sequence
telco disarming
sequence
unsealed
user code
zone
Table 6.1: Glossary of Terms
2014.05 | 01 | F01U298028
Description
A method of manually disabling (isolating) one or more zones before
arming the system.
A numeric code used for arming and disarming the system, and for
allowing access to all functions available through the codepad.
A secure location where a digital receiver monitors a number of alarm
systems and deciphers their alarm transmission reports so the operator
can advise the appropriate authorities to take immediate action.
A condition or type of alarm in which the user requires either immediate
police or medical assistance.
Refers to a zone's status. If a zone is sealed, the detection devices are
not violated and the zone indicator is not lit (that is, a reed switch is
closed or a detector is on standby waiting for an intrusion).
A feature that allows the control panel to recognize when detection
devices might have stopped working. Sensor watch monitors the
operation of a zone over a programmed time period.
An alarm that sounds only at a remote location, and gives no obvious
local indication that an alarm was sent out.
A condition that automatically isolates certain zones when the security
system is armed in this mode. Only the installer can program these
zones.
A condition that automatically isolates certain zones when the security
system is armed in this mode. The Master Code holder can program
these zones.
A feature that automatically diverts a telephone number to another
telephone when a security system is armed in AWAY Mode, the same as
using call forwarding.
An automatic suspension of diverting of the telephone when the system
is disarmed.
Refers to a zone's status. If a zone is unsealed, the detection devices
are violated and the zone indicator is lit (that is, a reed switch is open
or a detector noted an intrusion).
A numeric code used to arm and disarm the system.
A monitored input used to activate an alarm. A zone might be set up to
activate an alarm only when the system is armed or to operate whether
the system is armed or disarmed.
User's Guide
Control Panel
Bosch Security Systems, Inc.