Event Memory Recall; Day Alarm; Remote Arming By Telephone - Bosch Solution 880 Operating Manual

CC408 | Operators Guide | 18. Event Memory Recall

18. Event Memory Recall

Use this function to replay the last 40 events that
occurred to the system. The event memory history
replays all alarms and arming/disarming of the
system in AWAY Mode, STAY Mode 1, and STAY
Mode 2.
The system cannot differentiate between
arming the system in STAY Mode 1 or
STAY Mode 2.
How to Enter Event Memory
Enter your four-character Master Code followed by
the [8] and [#] keys (for example, [2 5 8 0 8 #]).
Three beeps sound. The last 40 events display one at
a time by the codepad indicators, starting from the
most recent event. A beep sounds as each event
displays.

19. Day Alarm

Day alarm allows a combination of zones to be
monitored during the disarmed state by beeping the
codepad buzzer. Only your installer can program
zones 1 to 4 to operate for day alarm.
Example
A day alarm can be set up at the front door of a shop
with a pressure mat or electronic beam that
customers activate as they enter and exit the shop. As
the customers walk onto the pressure mat or break
the electronic beam, the codepad buzzer beeps.
How to Turn Day Alarm On
Hold down the [4] key until three beeps sound.
Day alarm turns on. All zones programmed for day
alarm operation cause the codepad buzzer to beep
during the disarmed state when activated.
How to Turn Day Alarm Off
Hold down the [4] key until two beeps sound.
Day alarm turns off.
Bosch Security Systems | 5/04 | 920050O.OG.112
20. Remote Arming By
Telephone
Use this feature to arm your system from any remote
location using a telephone. For security reasons, the
system cannot be disarmed using this method. This
feature requires a touch-tone telephone. Your
installer must program this feature to operate.
How to Remotely Arm your System Using the
Telephone
1. Call the telephone number connected to your
control panel.
2. When the control panel answers the incoming
call, a short jingle is heard. To arm the system,
press the [*] key on the touch-tone telephone for
1 to 3 seconds.
If you hear modem tones when the control panel
answers the incoming call, the system was
programmed for remote programming functions
by your installer. Wait for a pause between the
tones before pressing the [*] key.
After releasing the [*] key on the touch-tone
telephone, two beeps sound indicating that the
system was armed in AWAY Mode.
3. Hang up the telephone and the system remains
armed.
If your installer programs answering
machine bypass, you must call the control
panel twice to make a connection with the
system. For example, call the telephone
number that your control panel is
connected to, let the call ring no more
than four rings, then hang up the
telephone. Wait a minimum of 8 seconds
before you call the control panel again.
EN | 15