Copying To Multiple Workstations - HP xw4550 Service And Technical Reference Manual

CAUTION:
target workstations are not the same model. For example, do not copy the setup configuration from one
workstation model to another.
1. Select a setup configuration to copy, and reboot the workstation.
2. As soon as the boot up process begins, press and hold the
Setup (F10) Utility. Press
NOTE:
and press and hold the
3. If you are using a diskette or other storage device, insert it now. If not, proceed.
4. Select File>Replicated Setup>Save to Removable Media. Follow the instructions on the screen
to create the configuration diskette.
5. Power off the workstation to be configured and insert the configuration diskette.
6. Power on the workstation to be configured.
7. Press and hold the
the title screen, if necessary.
8. Select File>Replicated Setup>Restore from Removable Media, and follow the instructions on
the screen.
9. Restart the workstation when the configuration is complete.

Copying to multiple workstations

CAUTION:
target workstations are not the same model. For example, do not copy the setup configuration from one
workstation model to another.
This method takes a little longer to prepare the configuration diskette, but copying the configuration to
target workstations is significantly faster. To copy to multiple workstations, complete the following steps:
NOTE: A bootable diskette is required for this procedure. If Windows Vista or Windows XP are not
available to use to create a bootable diskette, use the method for copying to a single workstation instead
(see Copying to a single workstation on page
1. Create a bootable diskette.
2. Select a setup configuration to copy.
3. Restart the workstation.
4. As soon as the workstation powers on, press and hold the
Setup (F10) Utility. Press
NOTE:
and press and hold the
5. If you are using a diskette or other storage device, insert it now.
34 Chapter 3 System management
A setup configuration is model-specific. File system corruption can result if source and
Enter
If you do not press the
F10 key again to access the utility.
F10 key until you enter the Computer Setup (F10) Utility. Press
A setup configuration is model-specific. File system corruption can result if source and
Enter
If you do not press the
F10 key again to access the utility.
to bypass the title screen, if necessary.
F10 key at the appropriate time, you must restart the workstation
33).
to bypass the title screen, if necessary.
F10 key at the appropriate time, you must restart the workstation
F10 key until you enter the Computer
F10 key until you enter the Computer
Enter to bypass
ENWW