HP xw4550 Service And Technical Reference Manual page 102

4. Connect the power cable (2) to the drive (as shown in the following figure). This will allow any
possible accumulated static electricity to discharge through the ground circuit of the power
connector before the drive data circuits are connected.
Figure 4-47
5. Connect the data cable (1) between the hard drive (shown in the previous figure) and the
appropriate serial ATA port (2 in the following figure) using the following port connection sequence:
●
Connect the first hard drive (SATA 0) to port SATA0 on the system board.
●
Connect the second hard drive (SATA 1) to port SATA1 on the system board.
Figure 4-48
94 Chapter 4 Removal and replacement procedures
Installing the SATA hard drive
Connecting the SATA data cable
ENWW