Locking The Solenoid Lock; Unlocking The Solenoid Lock; Using A Failsafe Key - HP xw4550 Service And Technical Reference Manual

CAUTION:
password prevents unauthorized access to the Computer Setup (F10) Utility.

Locking the solenoid lock

1. Power on or restart the workstation.
2. As soon as the workstation is powered on, press and hold the F10 key until you enter Computer
Setup. Press Enter to bypass the title screen, if necessary.
NOTE:
and press and hold the F10 key again to access the utility.
If you are using a PS2 keyboard, you might see a Keyboard Error message—disregard it.
3. Select Security>Smart Cover>Cover Lock>Lock.
4. Select Fire>Save Changes and Exit.

Unlocking the solenoid lock

1. Power on or restart the workstation.
2. As soon as the workstation is powered on, press and hold the F10 key until you enter Computer
Setup. Press Enter to bypass the title screen, if necessary.
NOTE:
and press and hold the F10 key again to access the utility.
If you are using a PS2 keyboard, you might see a Keyboard Error message—disregard it.
3. Select Security>Smart Cover>Cover Lock>Unlock.
4. Select Fire>Save Changes and Exit.

Using a FailSafe key

If you enable the hood lock, your will need a FailSafe Key in order to open the workstation side access
panel under the following conditions:
●
Power outage
●
Startup failure
●
PC component failure (such as processor or power supply)
●
Forgotten password
NOTE: The FailSafe Key is a workstation accessory that must be ordered from HP. Be prepared; order
this key before you actually need it.
You can order a FailSafe Key in either of the two following key configurations:
●
Smart Cover FailSafe Key, tamper-resistant T-15 wrench
●
Smart Cover FailSafe Key, tamper-resistant screwdriver bit.
To determine the correct HP part number for each key configuration, see http://partsurfer.hp.com.
To obtain the FailSafe Key, contact HP post sales support by telephone or online:
46 Chapter 3 System management
For maximum cover lock security, be sure to establish a setup password. The setup
If you do not press the F10 key at the appropriate time, you must restart the workstation
If you do not press the F10 key at the appropriate time, you must restart the workstation
ENWW