HP xw4550 Service And Technical Reference Manual page 39

Table 3-1 Computer Setup (F10) Utility menu descriptions (continued)
Heading
Power
Advanced**
ENWW
Option
Virtualization Technology – enables Virtualization Technology to increase workstation
performance.
OS Management of Embedded Security Device–enables/disables the ability of the operating
system to control the TPM device. This includes turning it on/off, initializing it, and resetting it.
Reset of Embedded Security Device through OS.–enables/disables the ability of the operating
system to reset the TPM.
Setup Security Enables the administrator to selectively set the security level for each setup feature. The options
Level are Setup Password and None. Browser mode must be enabled to use this option.
OS Power Enables/disables:
Management
●
ACPI S3 Hard Disk Reset
●
USB Wake on Device Insertion
●
Unique Sleep State Blink Rates
Thermal Enables you set the rate of the system fan when processor is in idle.
Power-On Allows you to set:
Options
●
POST Mode (QuickBoot, FullBoot, or FullBoot every 1–30 days).
●
POST Messages (Enable/Disable).
●
F9 Prompt (Enable/Disable). Enabling this feature displays the text F9=Boot Menu during
POST. Disabling this feature prevents the text from being displayed. However, pressing the
F9 key still accesses the boot menu.
● F10 Prompt (Enable/Disable). Enabling this feature displays the text F10=Setup during POST.
Disabling this feature prevents the text from being displayed, but pressing F10 still accesses
the Setup screen.
●
F11 Prompt (Enable/Disable). Makes the Factory Recovery option visible during POST.
Disabling this feature prevents the text from being displayed, but pressing F10 still accesses
the Setup screen. Factory Recovery Boot Support must be enabled to use this option.
● F12 Prompt (Enable/Disable). Enabling this feature displays F12=Network Service Boot
during POST. Disabling this feature prevents the text from being displayed but pressing F12
still forces the system to attempt booting from the network.
●
Factory Recovery Boot Support (Enable/Disable). Recovery partition (HDD) option available.
Vista leaves the factory with this support in place.
● Option ROM prompt* (Enable/Disable). Enabling this feature causes the system to display a
message before loading options ROMs.
●
Remote Wakeup Boot Source
● After Power Loss (On/Off); the previous state is the default.
● POST Delay (in seconds) (Enable/Disable). Enabling this feature adds a user-specified delay
to the POST process. This delay is sometimes needed for hard disks on some PCI cards that
spin up slowly—so slowly that they are not ready to boot by the time POST is finished. The
POST delay also gives you more time to select F10 to enter the Computer Setup (F10) Utility.
● Limit (CPUID Maximum Value to 3) (Enable/Disable)
Execute Tests workstation memory. The workstation reboots and any changes that have been made are
Memory Test lost. The workstation might boot with memory in a sub-optimal configuration.
BIOS Power-On Enables you to disable or specify a weekday and time for BIOS power-on.
Description
Computer Setup (F10) Utility 31