Installing A 3.5-Inch Drive Into A Drive Bay - HP 8200 Elite Series Maintenance And Service Manual

The 3.5-inch drive is located underneath the 5.25-inch drive. You must remove the 5.25-inch drive
before removing the 3.5-inch drive.
1. Follow the procedure in
the 5.25-inch drive and access the 3.5-inch drive.
CAUTION:
from the electrical outlet before proceeding.
2. Disconnect the drive cables from the rear of the drive, or, if you are removing a media card
reader, disconnect the USB cable from the system board as indicated in the following illustration.
Figure 8-18
3. Press down on the green drive retainer button located on the left side of the drive to disengage
the drive from the drive cage (1). While pressing the drive retainer button, slide the drive back
until it stops, then lift it up and out of the drive cage (2).
Figure 8-19

Installing a 3.5-inch Drive into a Drive Bay

The 3.5-inch bay is located underneath the 5.25-inch drive. To install a drive into the 3.5-inch bay:
184 Chapter 8 Removal and Replacement Procedures – Small Form Factor (SFF) Chassis
Removing a 5.25-inch Drive from a Drive Bay on page 181
Ensure that the computer is turned off and that the power cord is disconnected
Disconnecting the Media Card Reader USB Cable
Removing a 3.5-inch Drive (Media Card Reader Shown)
to remove