HP 8200 Elite Series Maintenance And Service Manual page 110

●
If you are installing the drive in the upper bay (bay 4), install three standard 6-32 silver
guide screws (two on the right side and one on the left side in the screw hole closest to the
power and data connectors).
Figure 6-26
4. Insert the hard drive into the bay as follows:
CAUTION:
of unnecessary force when installing any drive into the drive bay may result in damage to the
drive.
●
If you are installing a hard drive into one of the lower two bays (bays 5 and 6), slide the
hard drive into the drive bay until it locks. The drivelock automatically secures the drive in
the bay.
Figure 6-27
98 Chapter 6 Removal and Replacement Procedures – Convertible Minitower (CMT) Chassis
Installing Standard Guide Screws
Make sure the guide screws line up with the guide slots in the drive cage. The use
Installing a Hard Drive into the Lower Two Bays