Transmitting A Message - Icom IC-F3210D Operating Manual

2
IDAS OPERATION
Transmitting a call (Continued)
■
D

Transmitting a Message

< For only the IC-F3230D/IC-F4230D series and
IC-F5220D/IC-F6220D series transceivers>
The transceiver has the ability to send a preprogrammed
message.
There are 10 messages that can be sent on a channel.
Push [Digital Button] to enter the application selection
q
mode.
• "VOICE" appears.
• To change the call type, hold down [Digital Button] for 1 second
while in the standby mode. After changing, the transceiver auto-
matically enters the application selection mode.
Push [CH Up] or [CH Down] to select "MSG."
w
For the IC-F3230D/F4230D series transceivers
For the IC-F5220D/F6220D series transceivers
Push [Digital Button] again to enter the message selection
e
mode.
• The preprogrammed message is displayed.
22
Push [CH Up] or [CH Down] to select the desired mes-
r
sage.
• You can rewrite the contents of the message. See the next page
for details.
For the IC-F3230D/F4230D series transceivers
For the IC-F5220D/F6220D series transceivers
Convenient! (10-key version only)
✓
Depending on the presetting, you may use the quick mes-
sage selection/transmission in the message selection mode.
➥ Push the numeric key ([1] to [9] or [0]) to select the appro-
priate message, programmed in the SDM list 1 through 10.
➥ Hold down the numeric key ([1] to [9] or [0]) for 1 second to
transmit the appropriate message, programmed in the SDM
list 1 through 10.