Icom IC-F3210D Operating Manual page 8

1
PREPARATION
Programmable key functions
■
D Programmable key functions (Continued)
INDIVIDUAL
<For the IC-F3210D/F4210D series transceivers>
N/A
<For the IC-F3230D/F4230D/F5220D/F6220D series transceivers>
Push to set the call type to "Individual," and automatically
➥
enter the application selection mode*.
If in the application selection mode, push to enter the Indi-
➥
vidual ID selection mode*.
If "STATUS" or "MSG" is selected as the application, push
➥
to enter the message selection mode. After selecting a
message, push again to enter the Individual ID selection
mode.
Hold down for 1 second to return to the standby mode.
➥
TALKGROUP
<For the IC-F3210D/F4210D series transceivers>
N/A
<For the IC-F3230D/F4230D/F5220D/F6220D series transceivers>
Push to set the call type to "Talkgroup," and automatically
➥
enter the application selection mode*.
If in the application selection mode, push to enter the Talk-
➥
group ID selection mode*.
If "STATUS" or "MSG" is selected as the application, push
➥
to enter the message selection mode. After selecting a
message, push again to enter the Talkgroup ID selection
mode.
Hold down for 1 second to return to the standby mode.
➥
6
RESET
Push to reset the destination unit ID and call type to the
➥
default, if they have been changed by the manual opera-
tion.
Push to cancel the Talk Back function, if it is activated.
➥
While in the selection mode (e.g. application, message
➥
and status message), push to return to the stand-by mode.
In this case, the transceiver resets the destination unit ID,
call type and Talk Back function.
ROAM REQUEST
(This key is used for only Multi-site Trunk operation.)
Push to start a roaming scan, regardless of the error rate.
SITE LOCK
(This key is used for only Multi-site Trunk operation.)
Push to turn the Site Lock function ON or OFF.
When the Site Lock function is ON, the transceiver is locked
to the current registered site, and the roaming and the back-
ground scan are disabled.
* When the Digital/Individual/Talkgroup Key item is set to "ID Select"
in the optional cloning software, the ID selection mode will be se-
lected first. And while in the ID selection mode, push to select the
application selection mode.