Mercedes-Benz CLA Operator's Manual page 95

WARNING
G
The reversing feature does not react:
to soft, light and thin objects, e.g. small fin-
R
gers
when closing the roller sunblind again man-
R
ually immediately after automatic reversing
This means that the reversing feature cannot
prevent someone being trapped in these sit-
uations. There is a risk of injury.
When closing make sure that no parts of the
body are in the sweep of the roller sunblind.
If somebody becomes trapped:
release the switch immediately, or
R
during automatic operation, push the
R
switch briefly in any direction
The closing process is stopped.
Opening and closing
Overhead control panel
To open
:
To open
;
To close
=
Turn the SmartKey to position 1 or 2 in the
X
ignition lock ( page 141).
Y
Press or pull the 3 switch in the corre-
X
sponding direction.
i
If you press/pull the 3 switch beyond
the point of resistance, automatic opera-
tion is started in the corresponding direc-
tion. You can stop automatic operation by
pressing/pulling the switch again.
Panorama roof with power tilt/sliding panel
i
roller sunblind closes slightly automati-
cally. This reduces drafts in the vehicle inte-
rior.
Resetting the sliding sunroof and the
roller sunblind
Reset the sliding sunroof and the roller sun-
blind if the sliding sunroof or the roller sun-
blind does not move smoothly:
Turn the SmartKey to position 1 or 2 in the
X
ignition lock (
Pull the 3 switch repeatedly to the point
X
of resistance in the direction of arrow =
until the sliding sunroof is fully closed.
Keep the 3 switch pulled for an addi-
X
tional second.
Pull the 3 switch repeatedly to the point
X
of resistance in the direction of arrow =
until the roller sunblind is fully closed.
Keep the 3 switch pulled for an addi-
X
tional second.
Make sure that the sliding sunroof
X
(
Y
(
Y
again.
If this is not the case, repeat the steps
X
above again.
After opening the sliding sunroof, the
page 141).
Y
page 91) and the roller sunblind
page 93) can be fully opened and closed
93
Z