Mercedes-Benz CLA Operator's Manual page 345

Hide thumbs Also See for CLA:
Table of Contents

Advertisement

Observe the following when raising the
vehicle:
To raise the vehicle, only use the vehicle-
R
specific jack that has been tested and
approved by Mercedes-Benz. If used incor-
rectly, the jack could tip over with the vehi-
cle raised.
The jack is designed only to raise and hold
R
the vehicle for a short time while a wheel
is being changed. It is not suited for per-
forming maintenance work under the vehi-
cle.
Avoid changing the wheel on uphill and
R
downhill slopes.
Before raising the vehicle, secure it from
R
rolling away by applying the parking brake
and inserting wheel chocks. Do not disen-
gage the parking brake while the vehicle is
raised.
The jack must be placed on a firm, flat and
R
non-slip surface. On a loose surface, a
large, flat, load-bearing underlay must be
used. On a slippery surface, a non-slip
underlay must be used, e.g. rubber mats.
Do not use wooden blocks or similar
R
objects as a jack underlay. Otherwise, the
jack will not be able to achieve its load-
bearing capacity due to the restricted
height.
Make sure that the distance between the
R
underside of the tires and the ground does
not exceed 1.2 in (3 cm).
Never place your hands and feet under the
R
raised vehicle.
Do not lie under the vehicle.
R
Do not start the engine when the vehicle is
R
raised.
Do not open or close a door or the trunk lid
R
when the vehicle is raised.
Make sure that no persons are present in
R
the vehicle when the vehicle is raised.
Vehicles with steel wheels: the hub cap
covers the wheel bolts. Before you can
unscrew the wheel bolts, you must remove
the hub caps.
Changing a wheel
Steel wheel with hub caps
Using both hands, carefully reach into two
X
hub cap openings and remove the hub cap.
Using lug wrench :, loosen the bolts on
X
the wheel you wish to change by about one
full turn. Do not unscrew the bolts com-
pletely.
Jacking points
The jacking points are located just behind the
front wheel housings and just in front of the
rear wheel housings (arrows).
AMG vehicles and vehicles with AMG
equipment: to protect the vehicle body, the
343
Z

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents