Mercedes-Benz CLA Operator's Manual page 195

Hide thumbs Also See for CLA:
Table of Contents

Advertisement

The functionality of ATTENTION ASSIST is
restricted and warnings may be delayed or
not occur at all:
if the length of the journey is less than
R
approximately 30 minutes
if the road condition is poor, e.g. if the sur-
R
face is uneven or if there are potholes
if there is a strong side wind
R
if you have adopted a sporty driving style
R
with high cornering speeds or high rates of
acceleration
if you are predominantly driving slower
R
than 37 mph (60 km/h) or faster than
125 mph (200 km/h)
if the time has been set incorrectly
R
in active driving situations, such as when
R
you change lanes or change your speed
ATTENTION ASSIST is reset when you con-
tinue your journey and starts assessing your
tiredness again if:
you switch off the engine
R
you take off your seat belt and open the
R
driver's door, e.g. for a change of drivers or
to take a break
Displaying the attention level
You can have current status information dis-
played in the assistance menu (
of the on-board computer.
Select the Assistance display for Attention
X
Assist using the on-board computer
(
page 209).
Y
The following information is displayed:
length of the journey since the last break.
R
the attention level determined by ATTEN-
R
TION ASSIST
played in a bar display in five levels from
high to low
If ATTENTION ASSIST is unable to calculate
R
the attention level and cannot issue a warn-
ing, the
appears. The bar display then changes the
display, e.g. if you are driving at a speed
below 37 mph (60 km/h) or above 124 mph
(200 km/h).
Activating ATTENTION ASSIST
Activate ATTENTION ASSIST using the on-
X
board computer (
The system determines the attention level
of the driver depending on the setting
selected:
Selection
which the system determines the attention
level is set to normal.
Selection
higher. The attention level detected by Atten-
tion Assist is adapted accordingly and the
driver is warned earlier.
When ATTENTION ASSIST is deactivated, the
é symbol appears in the multifunction
display in the assistance graphic display.
When ATTENTION ASSIST has been deactiva-
ted, it is automatically reactivated after the
engine has been stopped. The sensitivity
selected corresponds to the last selection
activated (standard/sensitive).
Warning in the multifunction display
If fatigue or increasing lapses in concentra-
page 209)
tion are detected, a warning appears in the
Y
multifunction display:
Take a Break!
Take a
In addition to the message shown in the mul-
tifunction display, you will then hear a warn-
ing tone.
Driving systems
(Attention Level
Attention
Level), dis-
System Suspended
System Suspended
page 210).
Y
Standard: the sensitivity with
Standard
Sensitive: the sensitivity is set
Sensitive
ATTENTION ASSIST
ATTENTION ASSIST
Break!.
193
message
Z

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents