Table of Contents
Advertisement
General Troubleshooting
Symptom
No output or fog
machine is spitting
fluid
Circuit breaker or fuse
keeps blowing
Product does not
power up
Product does not
output fog
Page 12 of 12
Possible Cause
Incorrect fluid
Blocked pipe or failing part
Excessive load on the circuit
Short circuit along the power lines
No energy on power outlet
Loose or damaged power cord
Blown fuse
Internal problem
No fluid
Heater or pump clogged
Wired remote disconnected or
defective
Inappropriate wired remote operation
Wireless remote receiver not
connected
Wireless remote transmitter ran out of
battery
Wireless remote pair needs
configuration
Internal problem
If you still experience problems after trying the above solutions, contact Chauvet
Technical Support. See
Clean thoroughly with CHAUVET® FCQ. For
full instructions, see
Refill with CHAUVET® water-based fog fluid.
Contact Customer Service
Make sure that the total load does not exceed
80% of the breaker or fuse nominal current
Check the power lines and power cords
Check power outlet
Change to another outlet
Check the power cord
Replace blown fuse with a good one of the
same type and rating
Send product for repair
Turn the product off and replenish the fog fluid
(use only Chauvet fog fluid)
Use Chauvet cleaner to free the path.
Make sure that the remote is connected
Try the remote on another HURRICANE™
901
Read the instructions for both wired remote
units
Make sure that the wireless remote receiver is
connected
Replace battery on wireless remote transmitter
Make sure to configure the wireless remote
pair as per the instructions in this manual
Send the product for repair
Contact
Us.
Possible Action
Fogger
Maintenance.
Hurricane™ 901 User Manual Rev. 4
Advertisement
Table of Contents
