Table of Contents Table of Contents ................2 1. Before You Begin ................3 What Is Included ................... 3 Unpacking Instructions .................. 3 Claims ........................3 Manual Conventions ..................3 Symbols ......................3 Document Information ................... 3 Product at a Glance ..................4 Safety Notes ....................
If the container or the material inside the container (the product and included accessories) appear damaged from shipping, or show signs of mishandling, upon receipt notify the carrier immediately, not Chauvet. Failure to do so in a timely manner may invalidate your claim with the carrier. In addition, keep the container and all the packing material for inspection.
To eliminate unnecessary wear and improve its lifespan, during periods of non- use completely disconnect the product from power via breaker or by unplugging it. FCQ (Fog Cleaner Quart) was specifically developed by Chauvet to clean your Hurricane™ Haze 3D. Make sure you use FCQ regularly to increase the life of your product.
2. Introduction Product Overview Internal Fluid Tank Indicator Lights Safety Loop Digital Control Panel Display and Menu Buttons In/Out Wired Remote Controller Socket Power In Fuse Holder Power Switch Fluid Level Indicator Access Door and Storage Compartment for the HC-T Hurricane™...
3. Setup AC Power This product can work with an input voltage of either 120 VAC, 60 Hz or 230 VAC, 50 Hz depending on the model. To determine the power requirements for a particular product, see the label affixed to the back plate of the product or refer to the product’s specifications chart.
Mounting Orientation The Hurricane™ Haze 3D may not be tilted. This product should be mounted, placed on the ground, or on any oblique surface at a less than 15° angle to avoid the risk of the haze fluid tank leaking. Be sure there is adequate room for ventilation and programming.
Page 9
Mounting Clamp (such as CLP-15N Mounting Bracket clamp from Chauvet Safety Cable Mounting Diagram Bracket Adjustment Knob (2) Rubber Feet for floor mounting <15° <15° Hurricane™ Haze 3D User Manual Rev. 1 Page 9 of 16...
4. Operation Control To access the control board functions, use the three buttons located underneath the display. Panel Operation Button Function Press to scroll through the <MENU> operating modes ▲ Press to find a higher value < > UP ▼ Press to find a lower value <...
HC-T Wired The HC-T wired timer controller allows you to automatically trigger haze output by setting interval and duration times. LED indicator lights display the machine and Timer controller’s current state. Rotary knobs set interval and duration times, while manual Remote and continuous buttons allow overriding control.
Configuration Set this product in one of the standalone modes to control it without a DMX controller. Connect this product to a suitable power outlet. (Standalone Turn this product on. Mode) Manual Mode Never connect a product that is operating in any standalone mode, such as Manual mode, to a DMX string connected to a DMX controller.
Note: Do not operate the machine without fluid at any time. Fog Cleaner Quart (FCQ) was specifically developed by Chauvet to clean your Hurricane™ Haze 3D. Make sure you use FCQ regularly to increase the life of your product.
While the unit is operating; remove but do not disconnect the fluid tank and tilt the machine at a 45° angle. Empty fluid tank Refill tank with the correct CHAUVET® haze fluid If you still experience problems after trying the solutions presented here, contact Chauvet Technical Support.
Be prepared to provide the model number, serial number, and a brief description of the cause for the return. You must send the merchandise prepaid, in its original box, and with its original packing and accessories. Chauvet will not issue call tags.