General Troubleshooting; Technical Support - Chauvet Hurricane Haze 2 User Manual

General Troubleshooting

Symptom
Auto shut off
Breaker/Fuse keeps
blowing
Device has no power
Fixture is not responding
Fixture is on but there is
no movement to the audio
Loss of signal
Remote does not work
Stand alone mode
If you still have a problem after trying the above solutions, please contact CHAUVET®
Technical Support at the location below.

Technical Support

Address: Service Dept.
5200 NW 108
Sunrise, FL 33351
Support (Email): tech@chauvetlighting.com
Telephone: (954) 929-1115 - (Press 4)
Fax: (954) 929-5560 - (Attention: Service)
Website: http://www.chauvetlighting.com
Hurricane™ Haze 2 User Manual
Check thermal switch reset
Check total load placed on device
Check for power on Mains.
Check device's fuse. (internal and/or external)
Check DMX Dip switch settings for correct addressing
Check DMX cables
Check polarity switch settings
Make sure you have the correct audio mode on the control switches. If
audio provided via ¼" jack, make sure a live audio signal exists
Adjust sound sensitivity knob
Use only DMX cables
Install terminator
Note: Keep DMX cables separated from power cables or black lights.
Make sure connector is firmly connected to device
All CHAUVET® lighting fixtures featuring stand-alone functions do not
require additional settings, simply power the fixture and it will
automatically enter into this mode
th
Ave
13
Solution(s)
10/1/2010 5:13 PM