Seat Installation; Universal Mounting System And Contour Seat; Controller Harness Routing On A Synergy Seat - Pride Mobility Quantum Q6 Edge Owner's Manual

Powered wheelchair
Table of Contents

Advertisement

Seat Installation

It may be necessary to install the seat either prior to
initial operation or after transporting your power chair.
Contour seats are attached to the power base with the
Universal Mounting System (UMS). The UMS con-
sists of universal parts that may be attached to the seat,
regardless of seat width or seat depth. The two main
components are aluminum extrusions mounted to the
seat base. These extrusions attach to a pair of trapeze
bars that are mounted to the power base. See figure 11.
NOTE: If your power chair is equipped with a Spe-
cialty Seat, Synergy Seat, or a TRU-Balance Power
Positioning System, refer to the information provided
in separate manuals.
WARNING! Do not pick up the seat
frame by the armrests. They are free to
pivot, and you may lose control of the
seat if they do so.
To install the seat:
1. Tilt the seat back and slide the rear extrusion onto
the rear trapeze bar. See figure 11.
2. Lower the front extrusion onto the front trapeze bar
until the seat locks into place.
3. Flip the seat latch safety down.
WARNING! Make sure the seat latch
safety is flipped down before using
your power chair.
4. Install the controller and route the harness to the
back of the power base. See figures 12 or 13.
MANDATORY!
harness damage! Avoid routing the
controller harness on the outside of
the armrest pad. Route the harness
under the armrest or toward the inside
of the armrest pad. Use correct tie-
down points for controller harness to
prevent
the
caught in the drive tyres, pinched in
the seat frame, or damaged when
passing through doorways.
5. Plug the controller connector into the rear of the
power base. See figure 7.
6. Secure the controller harness to the armrest
receiver with wire ties. See figure 13.
22
I V . A S S E M B L Y
Prevent
controller
harness
from
getting
www.pridemobility.com
SEAT LATCH SAFETY
REAR
EXTRUSION
Figure 11. Universal Mounting System and Contour Seat
Figure 12. Controller Harness Routing on a Synergy Seat
FRONT EXTRUSION
TRAPEZE BARS
Quantum Q6 Edge

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents