Table of Contents
Advertisement
3. With the rear panel power switch in the Off position, connect the DC power adapter to
the Artis SE. A power cord is included to connect the adapter to an AC outlet. Before
plugging the cable into the AC outlet, check that the power is compatible with the Artis
SE (with voltages from 90 - 260 volts at 50–60 Hz). If your power source does not have
the standard three hole outlet, you should take the time to install a proper grounding
system. If your power outlet is not within these ranges it is recommended you use an
appropriate adaptor.
4. Plug the AC power cable into the wall.
5. Plug the Switch Pedal into the marked SW1 (Sustain) Pedal jack on the Artis SE rear
panel.
6. Connect stereo headphones to the headphone jack on the rear panel, or connect the
audio outputs to your mixer or amplifier inputs using standard (1/4-inch) audio cables
(use the Left out for mono). Balanced ("TRS" or "Stereo") cables are recommended if
your mixer or amp supports balanced inputs.
7. Make sure your sound system is at a safe volume level. Also make sure that the Artis SE
MASTER VOLUME slider (on the far left side of the front panel) is all the way down.
Music Rack (Optional)
The optional KMR2 Music Rack attachment is a holder for sheet music or a computer tablet
device. Contact your Kurzweil dealer for the KMR2 Music Rack.
Please refer to the instructions that come with the KMR2 on attaching the music rack to the
Artis SE.
Introducing Artis SE
Music Rack (Optional)
3
Advertisement
Table of Contents
