Connecting To Your Audio System - Kurzweil Artis SE Getting Started

Hide thumbs Also See for Artis SE:

Table of Contents

Introducing Artis SE

Connecting to Your Audio System

After you've turned down the level on your sound system, connect the Artis SE analog audio

outputs to your sound system using a pair of balanced (TRS or "stereo") or unbalanced

(TS or "mono") audio cables. Unbalanced cables will always work, but if you're going into

balanced inputs, use balanced cables for a better signal-to-noise ratio and a bit more volume.

The Artis SE analog outputs are balanced.

You'll find two 1/4-inch balanced audio output jacks on the rear panel. Connect one end of

each audio cable to your mixing board or PA system inputs, and connect the other end to the

jacks marked Left (Mono) and Right on the rear panel of the Artis SE. If you have only one

input available, use the Artis SE Left (Mono) output to get the full signal in mono. Use the

jack marked Headphones (located on the rear/left of the instrument) to listen to Artis SE on

headphones. When headphones are plugged in, sound still comes through the Left and Right

audio jacks.

Artis SE connected to powered speakers and headphones

Table of Contents