Mark top dead center
Oil filter wrench
In the position at
which the filter
gasket first contacts
the mounting
surface.
Tighten the filter
2 turns or
to specified torque.
11. Mark the top dead center position on the
"cap type" filter wrench or on the oil filter.
Use an oil filter wrench to tighten the fil-
ter 2 turns or to specified torque.
Oil filter tightening torque:
20 N·m (2.0 kgf-m, 14.5 lb-ft)
12. Pour 3300 ml (3.5/2.9 US/Imp. qt) of new
engine oil through the filler hole and
install the filler cap. Be sure to always
use the specified engine oil described in
the FUEL, ENGINE OIL AND COOLANT
RECOMMENDATIONS section.
NOTE: About 3100 ml (3.3/2.7 US/lmp. qt)
of oil will be required when changing oil only.
6-32